Our best-selling waterproof infrared heater was born for the one room that hates electronics: the bathroom. Steam. Condensation. The occasional splash. Most heaters fold under that kind of daily pressure. We built this one to push back—and keep pushing—so you’re not replacing it after a season. Power that stays steady, even when the air is wet We tuned the heat output so it feels consistent, not forced. The unit radiates warmth without pushing the core too hard, and the waterproof housing stays comfortably cool on the outside. It carries a solid IP rating, which just means the guts—the electronics and the heating element—are sealed away from water. No shorts. No corrosion. Just reliable heat, even in the soggiest zone. Built to fight fog, resist splash, and handle the heat cycle The quartz tube can take the sudden temperature shifts, and the outer surface has a special coating that manages condensation. So the heater stays clear, the light stays bright, and you don’t get hot spots from trapped moisture. The R7s connector holds tight even when things vibrate and expand with heat. And the front shield? It’s sealed to keep splashes out while still letting that strong infrared warmth through. Why it shines in the bathroom—and what to keep in mind Bathroom heaters live in short, intense bursts, and moisture makes that lifestyle brutal. Our design keeps water out and keeps the optics clear, so the unit starts dry and stays dry between cycles. You get warm-up behavior you can count on—and far fewer service calls. One thing to note: because the enclosure is sealed, it needs breathing room. Make sure you mount it with enough clearance so heat doesn’t build up. And if you’re swapping an old heater, this drops right in when the existing cutout matches the footprint.